Ym. Boiko et al., TENSILE, STRESS-RELAXATION AND DYNAMIC-MECHANICAL BEHAVIOR OF POLYETHYLENE CRYSTALLIZED FROM HIGHLY DEFORMED MELTS, Polymer, 36(7), 1995, pp. 1383-1392
High-density polyethylene (HDPT) specimens were obtained by standard e
xtrusion and also by a procedure of solidification from a highly defor
med melt (Sodem) in wide ranges of temperature T, time t, and draw rat
io lambda from 1.0 to 12.2. Tensile tests were conducted isothermally
between 20 and 120-degrees-C and stress relaxation at constant tensile
strain studied as a function of time also isothermally at several tem
peratures in the range from -50 to +100-degrees-C. Dynamic mechanical
testing was similarly conducted in the range from -150 to +120-degrees
-C. The time-temperature equivalence principle, an equation for the te
mperature shift factor a(T) as a function of the reduced volume v and
the Hartmann equation of state were applied to the properties so estab
lished, including the stress relaxation and the mechanical loss tangen
t. The earlier shift factor equation has been generalized so that it n
ow includes the draw ratio in two ways: In a(T) = 1/[a + clambda] + B/
[v - 1]; a, c and the Doolittle constant B are characteristic for a gi
ven material but independent of the degree of orientation and of tempe
rature. The reduced volume v depends on temperature T via equation (7)
and on lambda via equation (8). Drawing causes a decrease in the numb
er of available chain conformations, which is reflected in the first t
erm; it also changes intersegmental interactions, as reflected in the
second term through equation (8). The Sodem procedure improves mechani
cal properties of HDPE. Specimens with the highest draw ratio lambda =
12.2 exhibit the highest elastic modulus and the highest tensile stre
ngth as well as high relaxation rates during long-term testing.