E. Olevsky et al., PLANE CROSS-SECTION METHOD FOR MODELING THE PRESSING OF COMPLEX-SHAPEPOWDER ARTICLES IN RIGID DIES, Journal of the European Ceramic Society, 17(2-3), 1997, pp. 113-120
Densification processes in rigid dies are considered. The behaviour of
the powder products with inclined, curve and stepped surfaces is stud
ied. The influence of a pressing cyclogram on the distribution of resi
dual porosity is investigated. The analysis is based on the plane cros
s-section method. In the capacity of the procedure, promoting an optim
ization of densification, the subdivision of an article into separated
elements pressed by different punches is used. For components with in
clined surfaces, on the basis of the density distribution required for
the final product the most relevant methods of this subdivision are p
ointed out. (C) 1996 Elsevier Science Limited. .