Sdja. Arsecularatne et al., PREDICTION OF THE RADIAL FORCE IN TURNING USING FEED FORCE DATA, International journal of machine tools & manufacture, 33(6), 1993, pp. 827-839
This paper addresses the problem of calculating the radial force in tu
rning, when the feed force is known. The empirical equations presented
are used to predict the chip flow direction for tools with a nose rad
ius that may also have a cutting edge inclined to the direction of pri
mary motion. The predicted chip flow direction, measured feed force, k
nown tool geometry and cutting conditions are then used to predict the
radial force component. A comparison between the predicted and experi
mentally measured forces, for tools with a range of chipbreaker geomet
ries, shows good agreement.