Biomechanical evaluation of the dynamic hip screw with two- and four-hole side plates

Citation
Sw. Mcloughlin et al., Biomechanical evaluation of the dynamic hip screw with two- and four-hole side plates, J ORTHOP TR, 14(5), 2000, pp. 318-323
Citations number
19
Categorie Soggetti
Ortopedics, Rehabilitation & Sport Medicine
Journal title
JOURNAL OF ORTHOPAEDIC TRAUMA
ISSN journal
08905339 → ACNP
Volume
14
Issue
5
Year of publication
2000
Pages
318 - 323
Database
ISI
SICI code
0890-5339(200006/07)14:5<318:BEOTDH>2.0.ZU;2-Z
Abstract
Objectives: To determine the biomechanical strength and stiffness of a dyna mic hip screw (DHS; Synthes USA, Paoli, PA, U.S.A.) with a two-hole side-pl ate as compared with a four-hole side-plate design for the reconstruction o f unstable three-part intertrochanteric fractures. Design: Eight matched pairs of embalmed human femurs were tested in two mod es: (a) 2,000 cycles of simulated physiologic loading; (b) test to failure. Setting: Laboratory. Simulated single leg stance using a simulated pelvic l oading mechanism with abductor loading. Strain and displacement sensors wer e used to measure fragment shear and distraction and surface strain in the proximal side plate. Specimens: Eight pairs of skeletonized embalmed cadaveric specimens were se lected on the basis of femoral neck angle and absence of old fracture, anat omic anomaly, or pathology. Intervention: The specimens were divided into two groups: ia) left femurs r eceived the two-hole side-plate design; (b) right femurs received the four- hole side-plate design. All fractures were reconstructed by the same surgeo n using the manufacturer's instructions. Main Outcome Measurements: Implant placement was verified by radiographic m easurement of tip-to-apex distance. In cyclic testing, the amount of femora l neck fragment migration in both distraction and shear was quantified. Str ain magnitude in the side plate was measured in bath cyclic and failure tes ting. The peak load withstood by the reconstruction was quantified in the f ailure test. Results and Conclusions: Peak load in the failure test was not found to be statistically different between the two-hole and four-hole designs. In cycl ic testing, the two-hole configuration exhibited statistically smaller frag ment migration in both shear and distraction than the four-hole design (p < 0.05). The strain magnitude in the side plate was not statistically differ ent in the cyclic or failure tests. The femurs with a greater neck angle fa iled by crushing of the bone in the neck. The femurs with a lesser neck ang le failed due to bending of the hardware. The results of this investigation revealed that the two-hole DHS is biomechanically as stable as the four-ho le DHS in cyclic and failure loads under the conditions tested. These resul ts, in concert with clinical experience, can be used to support the use of the two-hole DHS for the reconstruction of intertrochanteric fractures with out a diaphyseal extension.