Er. Upchurch, Horizontal gravel-packing technique for slim, cased holes in highly permeable zones: A single-well case history, SPE DRILL C, 15(3), 2000, pp. 198-202
This paper describes a technique for horizontal gravel packing of slim, cas
ed holes. The key to the technique is the use of horizontally oriented perf
orations as a means of providing self-diversion of the gravel pack regardle
ss of fluid leakoff. Traditional horizontal gravel packing requires minimiz
ing fluid leakoff to the formation; otherwise, premature bridging can occur
during the gravel-packing process. The cased hole horizontal gravel-packin
g process presented here, however, does not require minimizing fluid leakof
f to the formation, thus, allowing the possibility of placing a gravel pack
in a horizontal casing with less resultant damage than is possible with tr
aditional techniques.
Gravel packing is becoming a common practice for controlling unconsolidated
sands in horizontal wellbores. So far, horizontal gravel packing has been
applied almost exclusively to open holes with screens in them. If a formati
on has a high permeability, and therefore, a high fluid-loss rate, placemen
t of a gravel pack may be prevented by premature dehydration and bridging o
f the gravel-pack sand in the wellbore/screen annulus. The usual method of
preventing these high fluid losses and the resultant bridging is to damage
the formation face prior to gravel packing. The damage mechanism is usually
salt, calcium carbonate, or other particles that seal off the formation fa
ce. Once gravel packing is completed, the formation damage is (hopefully) r
emediated using acid or undersaturated brines to restore the completion's p
roductivity. There is, however, a risk that the damage cannot be successful
ly removed once it is gravel packed against the formation face. Acid divers
ion is also a problem when attempting to remediate damage in an openhole gr
avel-packed completion.
This paper presents an alternative technique for performing a horizontal gr
avel pack in a high-permeability zone while reducing the risk of permanentl
y damaging the formation's permeability. The technique involves cementing c
asing through the horizontal completion interval and then shooting perforat
ions in a horizontal orientation. The perforations can then be acidized wit
h better diversion techniques than is possible in an openhole completion. A
n uncentralized screen is then gravel packed. The horizontally positioned p
erforations provide a self-diverting gravel pack. The self-diverting nature
of this technique makes it relatively insensitive to fluid loss; whereas o
penhole techniques are very sensitive to fluid loss. The uncentralized line
r rests on the bottom of the horizontal to provide maximum standoff from th
e perforations.
The above technique was applied at Thums Long Beach Company to a well with
a 560-ft horizontal completion cased with a 41/2-in. liner (4.052-in. ID).
The technique's acidizing phase, however, was not performed due to fishing
concerns inside the slim Liner. This paper presents a case history for grav
el;packing a 690-ft-long, 27/8-in.-slotted liner inside the horizontal 41/2
-in. casing. To our knowledge, this is the slimmest horizontal gravel pack
ever attempted. The gravel packing was performed successfully even though f
luid returns were never established during the job. The lack of fluid retur
ns is due to excessive fluid loss to the formation. The self-diverting natu
re of the horizontal perforations was the key to successful gravel packing.
Production rates, on the other hand, were not as successful since we did n
ot acidize the perforations prior to gravel packing. Comparisons between th
is well and openhole horizontal gravel packs are made.