Precipitation kinetics and strengthening of a Fe-0.8wt%Cu alloy

Precipitation kinetics and strengthening have been investigated for a Fe-0. 8wt%Cu alloy. Microstructure evolution during aging at 500 degreesC has bee n studied by a combination of Transmission Electron Microscopy and Small-An gle X-ray Scattering to provide information on the nature and location of t he precipitates as well as a quantitative estimate of their size and volume fraction. The associated mechanical properties have been studied by hardne ss and tensile tests. The precipitation kinetics measured in this study are fully compatible with results reported for alloys with higher Cu levels. Nucleation of Cu precip itates is promoted by the presence of dislocations whereas coarsening rates in the later stages of aging appear to be not affected by fast diffusion p aths along dislocations. The strength of individual precipitates increases with precipitate size bas ed on the analysis of the mechanical test results. However, the strength of the largest precipitates observed remains approximately half of the streng th required for the Orowan by-passing mechanism. The Russell-Brown model fo r modulus strengthening has successfully been applied to the current data. Study of the plastic behavior shows that the maximum initial hardening rate is related to the highest strength of the material. This unusual result ma y be explained by a dynamic strained-induced phase transformation of the pr ecipitates from the bce to the 9R structure. Consequently, the hardening po tential of Fe-Cu alloys is associated with good plastic properties close to peak strength thereby indicating the excellent potential of copper as hard ening element for the development of novel high strength interstitial free (IF) steels.