Residual strain in mechanically ground powders of Al-Ti base ternary and quaternary compounds with L1(2) single-phase at 1450 K

We examined the microstructural characters of L1(2)-type (Al,X,Y)(3)Ti (X,Y =Mn,Cr,Ag,Fe) phase alloys, with compositions selected from the regions con necting ternary L1(2)-type (Al, X)(3)Ti and (Al, Y)(3)Ti single-phase regio ns in the quaternary phase diagrams using laser microscopy, scanning electr on microscopy and electron probe microanalysis. The residual strain, which was induced during milling of the alloys, was measured by examining the X-r ay diffraction peak profile of the alloy powders. Most of the (Al, X, Y)(3) Ti alloys heat-treated at 1450 K for 24 h exhibited the L1(2) single-phase structure, while a few alloys containing Ag showed two-phase structures con sisting of L1(2) and Ag-rich phases. The lattice parameters of (At, Mn, Ag) (3)Ti arid (Al, Cr, Ag)(3)Ti increased remarkably with increasing Ag conten t, while those of (Al, Mn, Cr)(3)Ti, (Al, Mn, Fe)(3)Ti and (Al, Cr, Fe)(3)T i decreased gradually with increasing Cr or Fe content. The change of the l attice parameter with the contents of ternary and/or quaternary elements co uld be explained by the atomic size effect. The size and fraction of porosi ty, which were formed during heat treatment at 1450 K for 24 h, depended on the composition of the alloys. The changes of the size and fraction can be explained by the Kirkendall effect, irrespective of alloy systems. The inc rease of the residual strain by variation of the composition in the Al-Ti-M ri-Ag and Al-Ti-Cr-Ag systems may be explained by the fact that the decreas e of size and fraction of the porosity increased the residual strain. Howev er, in the Al-Ti-Mn-Cr, Al-Ti-Mn-Fe and Al-Ti-Cr-Fe systems, the change cou ld be explained by the fact that the residual strain increased as the sum o f the contents of Al and Ti decreased.