Three-body abrasion of a cast zinc-aluminium alloy: influence of Al2O3 dispersoid and abrasive medium

Three-body abrasive wear characteristics of a cast zinc-aluminium alloy -10 wt.% alumina particle composite have been analysed in the present investig ation. Silicon carbide, sand and zircon particles were used as the abrasive media. In order to see the influence of alumina dispersoid particles on th e abrasive wear behaviour, the similarly processed matrix alloy was also te sted under identical conditions. The composite exhibited less wear rate than the matrix alloy irrespective o f the test conditions. This was attributed to the wear resistance offered b y the hard dispersoid phase, thereby protecting the softer matrix. Further, the SiC abrasive caused maximum wear rate while the specimens experienced the minimum when abraded against zircon particles, sand particles led to in termediate wear response. Wear rate of the samples decreased progressively with distance until a steady-state value was attained. Abrasion-induced wor k hardening was thought to be responsible for the decreasing wear rate with distance. Increased hardness of the (subsurface) regions as compared to th at of the bulk also supported the view. Further, the rate of reduction in w ear rate with distance was relatively more for the matrix alloy than the co mposite. This behaviour was more clearly visible and, at the same time, the extent of reduction in the wear rate with distance was maximum in the case of the SiC abrasive. Sand was observed to be more damaging than zircon des pite its less hardness (than the latter). This could be owing to the sharp/ angular shape of the sand abrasive in comparison to the round shaped zircon particles suggesting the predominant effect of the particle shape over the hardness of the abrasive. More severe loading conditions led to larger wea r rates because of the greater depth of cut and more surface/subsurface dam age. Observed wear response of the samples has been supplemented with the f eatures of wear surfaces and subsurface regions. The latter also enabled an understanding of the operating wear mechanisms. (C) 2001 Elsevier Science B.V. All rights reserved.