Two important results desired in most powder-coating applications are: 1) a
high first-pass transfer efficiency (FPTE) and 2) uniformity of the powder
layer covering the surface to be coated. Both of these desired outcomes ar
e influenced by the properties of powder and spraying process parameters in
volved in the electrostatic coating process. Many industries are unable to
switch from solvent-based coatings to powder coatings because of the long c
olor-change time required in industrial powder coating processes. An FPTE g
reater than 90% may eliminate the need for recycling of the overspray in so
me applications, thereby permitting fast color changes. To obtain a high FP
TE and good appearance of a thin film, all relevant coating parameters must
be optimized. In many powder-coating applications, particularly in aircraf
t coating, it is necessary to reduce film thickness to reduce the weight of
the paint layer. However, the film must not have any surface defects and m
ust have strong resistance against corrosion, UV radiation, and temperature
fluctuations. Since surface defects can be caused by the presence of back
corona during the electrostatic spraying process, it is often desirable to
spray powder at high FPTE with minimal free ion current. To minimize ion cu
rrent, it is possible to operate the corona gun at a lower voltage, such as
-60 kV in place of -100 kV, with only minor reduction of FPTE but a threef
old reduction of Q/M of the deposited powder. However, since most of the po
lymer powder acquires a bipolar charge distribution during the fluidization
and transport processes, low-voltage corona discharge operations did not p
roduce unipolar charge distribution during the spraying process. A bipolar
charge distribution of the powder appears to produce dendritic clusters in
the powder layer, resulting in a nonuniform film surface, as measured by an
optical diffusive reflectance analyzer. The best film appearance was achie
ved with powder applied at -100 kV and cured slowly. It therefore appears t
hat each application process must be optimized by both experimental studies
and theoretical modeling to achieve the highest possible FPTE with minimal
surface defects.