AAAAAA
Results: 1-25/42
Authors:
SATHIKUMAR S
KARIHALOO BL
REID SG
Citation: S. Sathikumar et al., A MODEL FOR AGING VISCOELASTIC TENSION SOFTENING MATERIALS, MECHANICS OF COHESIVE-FRICTIONAL MATERIALS, 3(1), 1998, pp. 27-39
Authors:
LANGEKORNBAK D
KARIHALOO BL
Citation: D. Langekornbak et Bl. Karihaloo, DESIGN OF FIBER-REINFORCED DSP MIXES FOR MINIMUM BRITTLENESS, Advanced cement based materials, 7(3-4), 1998, pp. 89-101
Authors:
CHEN HR
WANG LM
KARIHALOO BL
WILLIAMS FW
Citation: Hr. Chen et al., FRACTURE-ANALYSIS FOR MULTIMATERIAL SYSTEM WITH AN INTERFACE CRACK, Computational materials science, 12(1), 1998, pp. 1-8
Authors:
KARIHALOO BL
ANDREASEN JH
Citation: Bl. Karihaloo et Jh. Andreasen, 2 PRACTICAL APPLICATIONS OF CRACK KINKING, Mechanics of materials, 28(1-4), 1998, pp. 263-270
Authors:
CHEN ZT
YU SW
KARIHALOO BL
Citation: Zt. Chen et al., ANTIPLANE SHEAR PROBLEM FOR A CRACK BETWEEN 2 DISSIMILAR PIEZOELECTRIC MATERIALS, International journal of fracture, 86(1-2), 1997, pp. 9-12
Authors:
WANG J
KARIHALOO BL
Citation: J. Wang et Bl. Karihaloo, MATRIX CRACK-INDUCED DELAMINATION IN COMPOSITE LAMINATES UNDER TRANSVERSE LOADING, Composite structures, 38(1-4), 1997, pp. 661-666
Authors:
KARIHALOO BL
WANG J
Citation: Bl. Karihaloo et J. Wang, MICROMECHANICAL MODELING OF STRAIN-HARDENING AND TENSION SOFTENING INCEMENTITIOUS COMPOSITES, Computational mechanics, 19(6), 1997, pp. 453-462
Authors:
ANDREASEN JH
KARIHALOO BL
Citation: Jh. Andreasen et Bl. Karihaloo, AN ACCURATE METHOD FOR SOLVING CRACK PROBLEMS WITH DISCONTINUOUS CRACK-LINE TRACTIONS, Computational mechanics, 19(6), 1997, pp. 496-500
Authors:
KARIHALOO BL
WANG J
Citation: Bl. Karihaloo et J. Wang, ON THE SOLUTION OF DOUBLY PERIODIC ARRAY OF CRACKS, Mechanics of materials, 26(4), 1997, pp. 209-212
Authors:
HAN SH
ADAMU A
KARIHALOO BL
Citation: Sh. Han et al., MINIMUM-COST DESIGN OF MULTISPAN PARTIALLY PRESTRESSED CONCRETE T-BEAMS USING DCOC, Structural optimization, 12(2-3), 1996, pp. 75-86
Authors:
THOMSEN NB
KARIHALOO BL
Citation: Nb. Thomsen et Bl. Karihaloo, ENHANCED WEAR PERFORMANCE OF TRANSFORMATION-TOUGHENED CERAMICS BY MICROSTRUCTURAL OPTIMIZATION, Journal of tribology, 118(4), 1996, pp. 740-747
Authors:
WANG J
KARIHALOO BL
Citation: J. Wang et Bl. Karihaloo, MODE-I STRESS SINGULARITY AND INTENSITY FACTOR AT A CRACK-TIP TERMINATING AT A TRANSVERSELY ISOTROPIC-ORTHOTROPIC BIMATERIAL INTERFACE, International journal of fracture, 74(4), 1996, pp. 325-340
Authors:
THOMSEN NB
KARIHALOO BL
Citation: Nb. Thomsen et Bl. Karihaloo, SUBSURFACE AND SURFACE CRACKS UNDER CONTACT LOADING IN TRANSFORMATION-TOUGHENED CERAMICS (VOL 44, PG 207, 1996), Journal of the mechanics and physics of solids, 44(7), 1996, pp. 1219-1219
Authors:
THOMSEN NB
KARIHALOO BL
Citation: Nb. Thomsen et Bl. Karihaloo, SUBSURFACE AND SURFACE CRACKS UNDER CONTACT LOADING IN TRANSFORMATION-TOUGHENED CERAMICS, Journal of the mechanics and physics of solids, 44(2), 1996, pp. 207-231
Authors:
KARIHALOO BL
WANG J
GRZYBOWSKI M
Citation: Bl. Karihaloo et al., DOUBLY PERIODIC ARRAYS OF BRIDGED CRACKS AND SHORT-FIBER-REINFORCED CEMENTITIOUS COMPOSITES, Journal of the mechanics and physics of solids, 44(10), 1996, pp. 1565-1586
Authors:
WANG J
KARIHALOO BL
Citation: J. Wang et Bl. Karihaloo, OPTIMUM IN-SITU STRENGTH DESIGN OF COMPOSITE LAMINATES .1. IN-SITU STRENGTH PARAMETERS, Journal of composite materials, 30(12), 1996, pp. 1314-1337
Authors:
WANG J
KARIHALOO BL
Citation: J. Wang et Bl. Karihaloo, OPTIMUM IN-SITU STRENGTH DESIGN OF COMPOSITE LAMINATES .2. OPTIMUM DESIGN, Journal of composite materials, 30(12), 1996, pp. 1338-1358
Authors:
MOLLER CV
ANDREASEN JH
KARIHALOO BL
Citation: Cv. Moller et al., IMPROVED ENDURANCE LIMIT OF ZIRCONIA CERAMICS BY OVERLOADING, Journal of the American Ceramic Society, 79(9), 1996, pp. 2500-2502
Authors:
MOLLER CV
KARIHALOO BL
Citation: Cv. Moller et Bl. Karihaloo, ARREST OF FATIGUE CRACKS IN TRANSFORMATION-TOUGHENED CERAMICS, Journal of the American Ceramic Society, 79(3), 1996, pp. 655-658
Authors:
ADAMU A
KARIHALOO BL
Citation: A. Adamu et Bl. Karihaloo, MINIMUM-COST DESIGN OF RC BEAMS WITH SEGMENTATION USING CONTINUUM-TYPE OPTIMALITY CRITERIA, Structural optimization, 9(3-4), 1995, pp. 220-235
Authors:
ADAMU A
KARIHALOO BL
Citation: A. Adamu et Bl. Karihaloo, MINIMUM-COST DESIGN OF RC FRAMES USING THE DCOC METHOD .1. COLUMNS UNDER UNIAXIAL BENDING ACTIONS, Structural optimization, 10(1), 1995, pp. 16-32
Authors:
ADAMU A
KARIHALOO BL
Citation: A. Adamu et Bl. Karihaloo, MINIMUM-COST DESIGN OF RC FRAMES USING THE DCOC METHOD .2. COLUMNS UNDER BIAXIAL BENDING ACTIONS, Structural optimization, 10(1), 1995, pp. 33-39
Authors:
MOLLER CV
KARIHALOO BL
Citation: Cv. Moller et Bl. Karihaloo, CRACK FRONT TRAPPING IN TRANSFORMATION-TOUGHENED CERAMICS, International journal of fracture, 72(2), 1995, pp. 171-181
Authors:
WANG J
KARIHALOO BL
Citation: J. Wang et Bl. Karihaloo, FRACTURE-MECHANICS AND OPTIMIZATION A USEFUL TOOL FOR FIBER-REINFORCED COMPOSITE DESIGN, Composite structures, 32(1-4), 1995, pp. 453-466
Authors:
MOLLER CV
KARIHALOO BL
Citation: Cv. Moller et Bl. Karihaloo, MULTIPLE CRACKS IN TRANSFORMATION-TOUGHENED CERAMICS, Mechanics of materials, 21(4), 1995, pp. 325-334