AAAAAA
Results:
1-9
|
Results: 9
Authors:
Samajdar, I
Ratchev, P
Verlinden, B
Aernoudt, E
Citation: I. Samajdar et al., Hot working of AA10 - Relating the microstructural and textural developments, ACT MATER, 49(10), 2001, pp. 1759-1769
Authors:
Desai, M
Dash, J
Samajdar, I
Venkataramani, N
Prasad, S
Kishan, P
Kumar, N
Citation: M. Desai et al., A TEM study on lithium zinc ferrite thin films and the microstructure correlation with the magnetic properties, J MAGN MAGN, 231(1), 2001, pp. 108-112
Authors:
Rajeev, R
Samajdar, I
Raman, R
Harendranath, CS
Kale, GB
Citation: R. Rajeev et al., Origin of hard and soft zone formation during cladding of austenitic/duplex stainless steel on plain carbon steel, MATER SCI T, 17(8), 2001, pp. 1005-1011
Authors:
Preschilla, N
Major, S
Kumar, N
Samajdar, I
Srinivasa, RS
Citation: N. Preschilla et al., Nanocrystalline gallium nitride thin films, APPL PHYS L, 77(12), 2000, pp. 1861-1863
Authors:
Samajdar, I
Verlinden, B
Watte, P
Mertens, F
Citation: I. Samajdar et al., Secondary recrystallization in non-Sag W filament wires - On the possible role of relative grain boundary character distribution, SCR MATER, 40(11), 1999, pp. 1263-1268
Authors:
Delannay, L
van Houtte, P
Samajdar, I
Citation: L. Delannay et al., Modelling of the microscopic strain heterogeneity during cold rolling of steel sheets. Prediction of the deformation texture, J PHYS IV, 9(P9), 1999, pp. 43-52
Authors:
Samajdar, I
Verlinden, B
Rabet, L
Van Houtte, P
Citation: I. Samajdar et al., Recrystallization texture in a cold rolled commercial purity aluminum: on the plausible macro- and micro-mechanisms, MAT SCI E A, 266(1-2), 1999, pp. 146-154
Authors:
Samajdar, I
Verlinden, B
Kestens, L
Van Houtte, P
Citation: I. Samajdar et al., Physical parameters related to the developments of recrystallization textures in an ultra low carbon steel, ACT MATER, 47(1), 1998, pp. 55-65
Authors:
Doherty, RD
Chen, LC
Samajdar, I
Citation: Rd. Doherty et al., Cube recrystallization texture - experimental results and modeling, MAT SCI E A, 257(1), 1998, pp. 18-36
Risultati:
1-9
|