Citation: A. Rohatgi et al., A metallographic and quantitative analysis of the influence of stacking fault energy on shock-hardening in Cu and Cu-Al alloys, ACT MATER, 49(3), 2001, pp. 427-438
Citation: A. Rohatgi et al., The influence of stacking fault energy on the mechanical behavior of Cu and Cu-Al alloys: Deformation twinning, work hardening, and dynamic recovery, MET MAT T A, 32(1), 2001, pp. 135-145
Citation: Cm. Cady et Gt. Gray, Influence of strain rate on the deformation and fracture response of a 6061-T6 Al-50 vol.% Al2O3 continuous-reinforced composite, MAT SCI E A, 298(1-2), 2001, pp. 56-62
Citation: Z. Jin et al., Deformation of a 45 degrees <(3)over-bar21 > oriented polysynthetically twinned TiAl crystal at high strain rate and high temperature, PHIL MAG A, 80(1), 2000, pp. 49-68
Citation: Gt. Gray et al., Influence of the shock-induced alpha-epsilon transition in Fe on its post-shock substructure evolution and mechanical behavior, J PHYS IV, 10(P9), 2000, pp. 755-760
Citation: Dm. Goto et al., The mechanical threshold stress constitutive-strength model description ofHY-100 steel, MET MAT T A, 31(8), 2000, pp. 1985-1996
Citation: Gc. Kaschner et Gt. Gray, The influence of crystallographic texture and interstitial impurities on the mechanical behavior of zirconium, MET MAT T A, 31(8), 2000, pp. 1997-2003
Authors:
Cady, CM
Chen, SR
Gray, GT
Korzekwa, DA
Bingert, JF
Citation: Cm. Cady et al., Dynamic materials testing, texture, and yield-surface calculation of an automotive sheet steel, MET MAT T A, 31(10), 2000, pp. 2439-2448
Authors:
Maudlin, PJ
Gray, GT
Cady, CM
Kaschner, GC
Citation: Pj. Maudlin et al., High-rate material modelling and validation using the Taylor cylinder impact test, PHI T ROY A, 357(1756), 1999, pp. 1707-1729
Authors:
Vaidya, RU
Jin, Z
Cady, C
Gray, GT
Butt, DP
Citation: Ru. Vaidya et al., A comparative study of the strain rate and temperature dependent compression behavior of Ti-46.5Al-3Nb-2Cr-0.2W and Ti-25Al-10Nb-3V-1Mo intermetallicalloys, SCR MATER, 41(6), 1999, pp. 569-574
Citation: Gt. Gray et al., Influence of grain size on the constitutive response and substructure evolution of MONEL 400, MET MAT T A, 30(5), 1999, pp. 1235-1247