Citation: L. Limmer et al., A combined testing and modelling approach to the prediction of the fretting fatigue performance of splined shafts, P I MEC E G, 215(G2), 2001, pp. 105-112
Citation: Jp. Hou et Da. Hills, Contact between a pin and a plate with a hole under interference-fit and clearance-fit conditions, P I MEC E C, 215(6), 2001, pp. 629-639
Citation: Mi. Porter et Da. Hills, Adhesive contact between a rigid punch and a half-plane via a thin, soft interlayer, J ENG MEC, 127(2), 2001, pp. 176-179
Citation: Da. Hills et D. Nowell, A discussion of: 'Peak contact pressure, cyclic stress amplitudes, contactsemi-width and slip amplitude: relative effects on fatigue life' by K. Iyer, INT J FATIG, 23(8), 2001, pp. 747-748
Citation: A. Sackfield et al., The tilted punch under normal and shear load (with application to frettingtests), INT J MECH, 43(8), 2001, pp. 1881-1892
Citation: G. Urriolagoitia-sosa et Da. Hills, A shrink-fit peg in a hole subjected to bending: unloading, reloading and frictional shakedown, J STRAIN A, 35(5), 2000, pp. 319-327
Citation: Am. Korsunsky et Da. Hills, Solution of axisymmetric crack problems using distributed dislocation ringdipoles, J STRAIN A, 35(5), 2000, pp. 373-382
Citation: Da. Hills et G. Urriolagoitia-sosa, Brief note: some observations on the parametric relationships in Hertzian fretting fatigue tests, J STRAIN A, 35(5), 2000, pp. 441-443
Citation: D. Nowell et al., Measurement of residual stresses in beams and plates using the crack compliance technique, J STRAIN A, 35(4), 2000, pp. 277-285
Citation: S. Lin et al., A theoretical investigation of sharp indentation testing of a nearly-brittle material, with some experimental results, J MECH PHYS, 48(10), 2000, pp. 2057-2075
Citation: M. Ciavarella et Da. Hills, A note on convective effects in elastic contact problems for dissimilar materials, EUR J MEC A, 18(3), 1999, pp. 481-490
Citation: M. Ciavarella et Da. Hills, Brief note: Some observations on oscillating tangential forces and wear ingeneral plane contacts, EUR J MEC A, 18(3), 1999, pp. 491-497
Citation: M. Ciavarella et Da. Hills, The influence of the indenter tip-radius on indentation testing of brittlematerials, J EUR CERAM, 19(2), 1999, pp. 239-245
Authors:
Ciavarella, H
Decuzzi, P
Demelio, G
Monno, G
Hills, DA
Citation: H. Ciavarella et al., The design of hydrodynamically lubricated journal bearings against yield (vol 34, pg 165173, 1999), J STRAIN A, 34(5), 1999, pp. 371-371