Authors:
Li, LH
Zhang, HQ
Cui, XM
Zhang, YH
Xia, LF
Ma, XX
Sun, Y
Citation: Lh. Li et al., Comparative analysis of DLC flim fine structure by Raman spectra and X-rayphotoelectron spectroscopy, ACT PHY C E, 50(8), 2001, pp. 1549-1554
Citation: G. Li et Lf. Xia, Structural characterization of TiCx films prepared by plasma based ion implantation, THIN SOL FI, 396(1-2), 2001, pp. 16-22
Authors:
Ma, XX
Che, RC
Sun, MR
Sun, Y
Xia, LF
Li, XD
Citation: Xx. Ma et al., Microstructural characterization of N, Ti mixed coatings deposited by plasma based ion implantation and magnetron sputtering deposition, J MAT SCI L, 19(8), 2000, pp. 635-638
Citation: Zj. Zhan et al., The mechanical properties of an aluminum alloy by plasma-based ion implantation and solution-aging treatment, SURF COAT, 128, 2000, pp. 256-259
Authors:
Ma, XX
Li, XD
Sun, Y
Xia, LF
Sun, MR
Li, G
Citation: Xx. Ma et al., Preparation of Ti/N and Ag/TiNx multilayers by plasma based ion implantation with multi-targets unbalanced magnetron sputtering, MATER LETT, 44(3-4), 2000, pp. 170-174
Citation: Q. Sun et al., Simulation of a diamond-shaped target with different sizes in plasma basedion implantation, J PHYS D, 33(20), 2000, pp. 2647-2652
Citation: Hb. Ji et al., Tribological behavior of TiC/DLC multilayers prepared on Ti-6Al-4V alloy by plasma-based ion implantation, J VAC SCI B, 17(6), 1999, pp. 2575-2580
Citation: Hb. Ji et al., Tribological behaviour of duplex treated Ti-6Al-4V: combining nitrogen PSII with a DLC coating, TRIBOL INT, 32(5), 1999, pp. 265-273
Citation: Lh. Li et al., XPS of Ti plus TIN plus (N,C) multilayer films deposited by filtered cathodic are deposition with controlled feed gas flow rate, SURF COAT, 121, 1999, pp. 618-621
Citation: Lf. Xia et al., Structure and frictional characteristics of Ti-6Al-4V plasma-based ion implanted with nitrogen then acetylene, WEAR, 229(2), 1999, pp. 835-842
Citation: Zj. Zhan et al., Tribological behavior of aluminum alloys surface layer implanted with nitrogen ions by plasma immersion ion implantation, WEAR, 220(2), 1998, pp. 161-167