Citation: Nh. Kim et al., Optimization of a hyper-elastic structure with multibody contact using continuum-based shape design sensitivity analysis, ST MULT OPT, 21(3), 2001, pp. 196-208
Citation: Nh. Kim et al., Structural optimization of finite deformation elastoplasticity using continuum-based shape design sensitivity formulation, COMPUT STRU, 79(20-21), 2001, pp. 1959-1976
Citation: Hw. Kim et al., Configuration design sensitivity analysis of dynamics for constrained mechanical systems, COMPUT METH, 190(40-41), 2001, pp. 5271-5282
Citation: Kk. Choi et Sw. Rhee, Chemical vapor deposition of copper film from hexafluoroacetylacetonateCu((I))vinylcyclohexane, THIN SOL FI, 397(1-2), 2001, pp. 70-77
Citation: J. Yao et al., Optimization of high detectivity infrared hot-electron transistors at low temperature, IEEE DEVICE, 48(7), 2001, pp. 1318-1321
Citation: Nh. Kim et Kk. Choi, Nucleate pool boiling on structured enhanced tubes having pores with connecting gaps, INT J HEAT, 44(1), 2001, pp. 17-28
Citation: Kk. Choi et Sw. Rhee, Effect of carrier gas on chemical vapor deposition of copper with (hexafluoroacetylacetonate) Cu-(I)(3,3-dimethyl-1-bulene), J ELCHEM SO, 148(7), 2001, pp. C473-C478
Citation: Nh. Kim et al., Meshless shape design sensitivity analysis and optimization for contact problem with friction, COMPUT MECH, 25(2-3), 2000, pp. 157-168
Authors:
Lin, SY
Fleming, JG
Chow, E
Bur, J
Choi, KK
Goldberg, A
Citation: Sy. Lin et al., Enhancement and suppression of thermal emission by a three-dimensional photonic crystal, PHYS REV B, 62(4), 2000, pp. R2243-R2246
Citation: Kk. Choi et W. Duan, Design sensitivity analysis and shape optimization of structural components with hyperelastic material, COMPUT METH, 187(1-2), 2000, pp. 219-243
Citation: S. Cho et Kk. Choi, Design sensitivity analysis and optimization of non-linear transient dynamics. Part I - sizing design, INT J NUM M, 48(3), 2000, pp. 351-373
Citation: S. Cho et Kk. Choi, Design sensitivity analysis and optimization of non-linear transient dynamics. Part II - configuration design, INT J NUM M, 48(3), 2000, pp. 375-399