AAAAAA

   
Results: 1-22 |
Results: 22

Authors: Jeng, MJ Wang, HT Chang, LB Lin, RM
Citation: Mj. Jeng et al., Surface passivation using P2S5/(NH4)(2)S-x and hydrogen fluoride solutionson Ag/n-InAs and Ag/n-InSb Schottky diodes, JPN J A P 1, 40(2A), 2001, pp. 562-564

Authors: Xu, LM Guo, N Lin, RM Du, H Deng, CD
Citation: Lm. Xu et al., Measurement and analysis of bearing and pivot stiffness in hard disk drives, J INF S P S, 3(3-4), 2001, pp. 237-245

Authors: Zeng, S Xu, LM Lin, RM
Citation: S. Zeng et al., Head actuator dynamics, P I MEC E I, 215(I1), 2001, pp. 1-13

Authors: Li, XX Lin, RM Kek, H Miao, JM Zou, QB
Citation: Xx. Li et al., Sensitivity-improved silicon condenser microphone with a novel single deeply corrugated diaphragm, SENS ACTU-A, 92(1-3), 2001, pp. 257-262

Authors: Lin, RM Tsai, KH Chu, LP Chang, PQ
Citation: Rm. Lin et al., Characteristics of sagittal vertebral alignment in flexion determined by dynamic radiographs of the cervical spine, SPINE, 26(3), 2001, pp. 256-261

Authors: Chen, LQ Miao, JM Guo, LH Lin, RM
Citation: Lq. Chen et al., Control of stress in highly doped polysilicon multi-layer diaphragm structure, SURF COAT, 141(1), 2001, pp. 96-102

Authors: Fu, L Miao, JM Li, XX Lin, RM
Citation: L. Fu et al., Study of deep silicon etching for micro-gyroscope fabrication, APPL SURF S, 177(1-2), 2001, pp. 78-84

Authors: Lin, RM Tang, SF Lee, SC Kuan, CH
Citation: Rm. Lin et al., Improvement of current leakage in the InAs photodetector by molecular beamepitaxy, J CRYST GR, 227, 2001, pp. 167-171

Authors: Lin, RM Lee, SC Lin, HH Dai, YT Chen, YF
Citation: Rm. Lin et al., Blueshift of photoluminescence peak in ten periods InAs quantum dots superlattice, J CRYST GR, 227, 2001, pp. 1034-1038

Authors: Zeng, S Lin, RM Xu, LM
Citation: S. Zeng et al., Novel method for minimizing track seeking residual vibrations of hard diskdrives, IEEE MAGNET, 37(3), 2001, pp. 1146-1156

Authors: Xu, LM Zeng, S Guo, N Lin, RM Hu, CM
Citation: Lm. Xu et al., Measurement and modeling of quasi-rigid-body modes in the head actuator assembly, J INF S P S, 2(3), 2000, pp. 141-150

Authors: Lin, RM Tang, SF Kuan, CH
Citation: Rm. Lin et al., Study sf current leakage in InAs p-i-n photodetectors, J VAC SCI B, 18(6), 2000, pp. 2624-2626

Authors: Li, XX Lin, RM Leow, KW
Citation: Xx. Li et al., Performance-enhanced micro-machined resonant systems with two-degrees-of-freedom resonators, J MICROM M, 10(4), 2000, pp. 534-539

Authors: Li, XX Lin, RM Miao, JM Bao, MH
Citation: Xx. Li et al., Study on convex-corner undercutting formed by masked-maskless etching in aqueous KOH, J MICROM M, 10(3), 2000, pp. 309-313

Authors: Guo, LH Lin, RM
Citation: Lh. Guo et Rm. Lin, Studies on the formation of microcrystalline silicon with PECVD under low and high working pressure, THIN SOL FI, 376(1-2), 2000, pp. 249-254

Authors: Yang, QJ Pang, HLJ Wang, ZP Lim, GH Yap, FF Lin, RM
Citation: Qj. Yang et al., Vibration reliability characterization of PBGA assemblies, MICROEL REL, 40(7), 2000, pp. 1097-1107

Authors: Jeng, MJ Wang, HT Chang, LB Cheng, YC Lee, CM Lin, RM
Citation: Mj. Jeng et al., Barrier height enhancement of Ni/N-type InP Schottky contact using a thin praseodymium interlayer, JPN J A P 2, 38(12A), 1999, pp. L1382-L1384

Authors: Zou, QB Sridhar, U Lin, RM
Citation: Qb. Zou et al., A study on micromachined bimetallic actuation, SENS ACTU-A, 78(2-3), 1999, pp. 212-219

Authors: Zou, QB Wang, ZF Lin, RM Pang, JT Tan, ZM Qian, X Liu, LT Li, ZJ
Citation: Qb. Zou et al., CoMSaT: a single-chip fabrication technique for three-dimensional integrated fluid systems, SENS ACTU-A, 72(2), 1999, pp. 115-124

Authors: Lin, RM Chang, GL Chang, LT
Citation: Rm. Lin et al., Biomechanical properties of muscle-tendon unit under high-speed passive stretch, CLIN BIOMEC, 14(6), 1999, pp. 412-417

Authors: Zhang, JM Lin, RM Wang, MJJ
Citation: Jm. Zhang et al., The development of an automatic post-sawing inspection system using computer vision techniques, COMPUT IND, 40(1), 1999, pp. 51-60

Authors: Lin, RM
Citation: Rm. Lin, Generalized receptance-based method for accurate and efficient modal synthesis, INT J NUM M, 44(11), 1999, pp. 1749-1767
Risultati: 1-22 |